Dryer Vent Hose Replacement in Winchester, CA

Why does the hose behind my dryer keep crushing?

Usually the cabinetry. Winchester laundry rooms built after 2000 run deep lower cabinets beside the dryer. The dryer gets pushed flat to the wall. The transition hose folds into a kink at the elbow. Foil accordion is the worst offender here. It traps lint in every ridge. Semi-rigid aluminum holds its shape better. A periscope fitting solves tight clearance outright. That is often the real fix, not a new hose.

Replacement is not just swapping parts. We check what the hose connects to. In 1960s-80s single-story homes and 55+ park housing, the garage-wall run is short and the wall stub is often crimped backward. In stacked condo and townhome chases, the transition feeds a riser you cannot see from the laundry room. Second-floor laundries push a long attic run to a roof jack. Sagging foil between trusses holds lint pools up there.

Local dust matters. Decomposed granite and field dust bind with lint into a dense mat. Santa Ana wind drives dust back down roof terminations. Cold inland nights add condensation, which cakes loose lint solid.

Clamps go on both ends, no tape alone. Length stays short and straight. If your dryer still runs long after a new hose, the problem is downstream, and we say so.